一种基于融合技术的成捆棒材端面图象的分割方案

王培珍; 杨维翰; 杜培明

doi:10.11834/jig.2003011469

学术论文与技术报告 | 浏览量 : 0 下载量: 185 CSCD: 0

PDF
导出
分享
收藏
专辑

一种基于融合技术的成捆棒材端面图象的分割方案
A Segmentation Approach Based on Fusion Technique for the End Image of Bundled Bar Steel
2003年8卷第11期页码：1277
纸质出版：2003
DOI： 10.11834/jig.2003011469
稿件说明：

移动端阅览

王培珍, 杨维翰, 杜培明. 一种基于融合技术的成捆棒材端面图象的分割方案[J]. 中国图象图形学报, 2003,8(11):1277. DOI： 10.11834/jig.2003011469.

A Segmentation Approach Based on Fusion Technique for the End Image of Bundled Bar Steel[J]. Journal of Image and Graphics, 2003, 8(11): 1277. DOI： 10.11834/jig.2003011469.

摘要

针对特定工业现场环境下成捆棒材端面图象的分割问题

提出了一种基于融合技术的图象分割方案.该方案先分别采用阈值化与基于边界的分割方法对图象进行初始分割

然后将所得数据加以关联

并采用遗传算法加以融合与提取.实验结果表明

该方案在不明显增加计算量的同时

使分割质量有了明显提高.

Abstract

In view of industrial spot and the particular requirements of the segmentation for the end image when the bar steel were bundled up

a new image segmentation approach is presented. At first. the image is preliminary segmented with threshold method and edge based method

by using the fast 2-D entropic thresholding algorithm and the simple gradient operator respectively. Then the results from the two methods are fused and integrated

the target areas are identified and the adhesions are removed

in which genetic algorithm is implemented. The fusion-based technique is shown to perform very well in terms of robustness to noise and adhesions

and the calculating time is not evidently added. The experimental result shows that the proposed approach is efficient in improving the quality of segmentation and fitting the industrial requirement.